Learning to weld on the job

Learning to weld on the job

3 Replies to “Learning to weld on the job”

  1. clean + shiney and good penetration. What welder is it and is it mig/arc? If mig were you using 0.8 or 1mm wire and normal Co2 or Argoshild?

  2. It’s using CO2, not sure of wire gauge. It’s a Kemppi Mig. I want to try again and use less weld in a more uniform way. I can see how hard it must be to weld sheet metal, I think I’d punch a hole straight through!

Leave a Reply

Your email address will not be published. Required fields are marked *